Asterisk setup success 1

Hardware Configurations

Machine name phone:

• SuperMicro 5011E
  • 1200 PIII
  • 256 megs memory
  • 40 gig IDE HD
  • Digium T400P
  • ADIT 600 Channelbank

Machine name pbx:

• Generic system
  • 1100 Celeron
  • 256 megs memory
  • 80 gig IDE HD
  • Digium T100P
  • Zhone Zplex 10b Channelbank

Description of deployment.

• 1 PRI from Telcove(formerly Adelphia) into phone located at our Colocation provider.
• 1 point to point T1 from Telcove for data traffic from Colocation to our office.
• The phone machine acts as a switch only, and has little local load.
• phone splits off 1 DID to the local ADIT 600 for a legacy answering system.
• phone sends the rest of our 19 DID lines to pbx via GSM compressed IAX2 protocol.
• The machine named pbx does local extension work.
• pbx is used as a development platform for our software to replace legacy answering system.
• 23 incoming lines with 10-13 lines peak being used on the legacy system, and 2-4 lines peak being used as extensions.
• Has been in nearly fault free operation since 05-2002.

• Back to Asterisk hardware recommendations