Using the Manager interface, I issue an Originate command. It indeed dials, and is handled in the dialpan, but the DIALSTATUS value is empty (I have tried answered and unanswered calls).
I am using Trixbox 2.6.18-53.1.4.el5 (SMP)
Any idea why this is so? (How can I determine how the call went?)
exten => s,1,NoOp(HANGUPCAUSE is ${HANGUPCAUSE})
...
I have a Cisco 7912G phone with SCCP ver 1.03 and I tried to load SIP 8.01 then SIP 1.01 via TFTP but it's not working. While I am able to go into the Network Configuration and specify the TFTP IP Address, IP Address and other functions when I save and reboot the phone it just goes off into an endless loop of searching for previous CallManager IP 10.24.97.1>Configuring VLAN>Configuring IP via DHCP> Repeat. The only thing that gets transferred via TFTP is the "gkdefault.cfg" file. I would see in status messages on the phone that TFTP times out even though the TFTP Address and, Laptop IP is correct and I turned off the firewall.
I previously read on this site I need to set the Profile Encrypt Key to "0" so the SIP firmware will auto load into the phone but when I go to Menu Key-> Settings-> Network Configuration -> The Profile Encrypt Key option doesn't exist.
...
Comments