voip-info.org

Page content
Page navigation
Page extras

History

http://www.ceon.com/

Packetcable provisioning and ordering systems.

Page content
Page navigation
Page extras

Last modif pages

Free VOIP Call Center Buyer's Guide

Get Help

Ask a question

Please Help: USB Plug and Play SIP VOIP-PHONE
by busylord Sun 05 of Oct, 2008
Dear All,

I have checked most of the USB IP Phone products in the markets, but they are not more than a sound card in a telephone like box. Therefore for using these kinds of USB IP Phones, you must first install a soft phone and then change the audio configuration of the softphone to use this USB Sound card for audio and microphone.
...
Cisco 7975 NTP Config
by mroooooooo Fri 03 of Oct, 2008
Can someone shed a little light on where I may be going wrong here. I have a Cisco 7975 setup and registered to my SIP Server - but the NTP will not synch. I have verified with Wireshark - I am getting NTP traffic. I have tried various configurations, with no resolution.

Any help would be greatly appreciated...
...
Re: Where to start? Want to set up VOIP PBX with analogue fallback for small business
by wa1cfs Thu 02 of Oct, 2008
Honestly, from the perspective of an engineer for a business VoIP provider, you don't want to host the PBX on your end. We have numerous customers running Fonality, homegrown Asterisk boxes, etc - most of them eventually wash out and get either a hosted solution or go back to analog. If your business isn't telecom, you don't want to be managing that infrastructure. For large companies with Cisco CallManager it might make sense to host premise based, but that is because it is economical to have a full-time telecom person. Without a doubt, if you are looking for VoIP with analog failover you are best still going hosted and then doing a premise based analog backup (ie. using a Cisco IAD).

-Jack