voip-info.org

Page content
Page navigation
Page extras

Dante's DIAX Software Phone

http://www.laser.com/dante/diax/diax.html

From Website:

This is a full featured and very small (just around 100KB for all the files) IAX based software phone for Microsoft Windows platforms (only).

Tips:

As of version 0.9.6, you must enter at least one digit before DIAX will allow you to dial. To dial with no number (ie to get to the Asterisk s extension) use a phonebook entry with an empty number string.

Howtos:

Howto on connecting diax on Asterisk

Originate dials ok but no DIALSTATUS
by simonInOz Tue 26 of Aug, 2008
Using the Manager interface, I issue an Originate command. It indeed dials, and is handled in the dialpan, but the DIALSTATUS value is empty (I have tried answered and unanswered calls).
I am using Trixbox 2.6.18-53.1.4.el5 (SMP)
Any idea why this is so? (How can I determine how the call went?)

exten => s,1,NoOp(HANGUPCAUSE is ${HANGUPCAUSE})
...
Re: SIpura + VOIP solution
by admin Mon 25 of Aug, 2008
To get a DID number you need a VOIP service provider:
VOIP Service Providers
There are some free services, and a number of low-cost vendors.
SIpura + VOIP solution
by ratlewhisk Mon 25 of Aug, 2008
Hi ,

I have a SPA 3000 + ADSL connection + analogue phone
things i do require to set up a voip connection.
As as i researched
...
STARTING UP NEW CALLING CARD BUSINESS
by kotel Sun 24 of Aug, 2008
Hello everybody, any ideas which company offer the most reliable automated online Calling Card Platforms or VoIP plans for start ups ?
please advise ,
Cisco 7912G caught in a startup loop
by madturtle Mon 18 of Aug, 2008
Hello everyone,

I have a Cisco 7912G phone with SCCP ver 1.03 and I tried to load SIP 8.01 then SIP 1.01 via TFTP but it's not working. While I am able to go into the Network Configuration and specify the TFTP IP Address, IP Address and other functions when I save and reboot the phone it just goes off into an endless loop of searching for previous CallManager IP 10.24.97.1>Configuring VLAN>Configuring IP via DHCP> Repeat. The only thing that gets transferred via TFTP is the "gkdefault.cfg" file. I would see in status messages on the phone that TFTP times out even though the TFTP Address and, Laptop IP is correct and I turned off the firewall.

I previously read on this site I need to set the Profile Encrypt Key to "0" so the SIP firmware will auto load into the phone but when I go to Menu Key-> Settings-> Network Configuration -> The Profile Encrypt Key option doesn't exist.
...