This page is to collect information on setting up Telus PRIs with Asterisk. We found their provisioning department to be very knowledgeable and ready to help
Using a Sangoma A101 and Echo Canceller with Asterisk 1.4
/etc/zaptel.conf
loadzone=us
defaultzone=us
#Sangoma A101 port 1 [slot:4 bus:3 span:1] <wanpipe1>
span=1,1,0,esf,b8zs
bchan=1-23
hardhdlc=24
/etc/asterisk/zapata.conf
[trunkgroups]
[channels]
context=default
usecallerid=yes
hidecallerid=no
callwaiting=yes
usecallingpres=yes
callwaitingcallerid=yes
threewaycalling=yes
transfer=yes
canpark=yes
cancallforward=yes
callreturn=yes
echocancel=yes
echocancelwhenbridged=yes
relaxdtmf=yes
rxgain=0.0
txgain=0.0
group=1
callgroup=1
pickupgroup=1
immediate=no
;Sangoma A101 port 1 [slot:4 bus:3 span:1] <wanpipe1>
;You may want to confirm with Telus that your PRI is connected to a Nortel DMS100. “national” may also work.
switchtype=dms100
context=from-pstn
group=0
signalling=pri_cpe
channel =>1-23
/etc/asterisk/wanpipe/wanpipe1.conf
#================================================
# WANPIPE1 Configuration File
#================================================
#
# Date: Wed Dec 6 20:29:03 UTC 2006
#
# Note: This file was generated automatically
# by /usr/local/sbin/setup-sangoma program.
#
# If you want to edit this file, it is
# recommended that you use wancfg program
# to do so.
# to do so.
#================================================
# Sangoma Technologies Inc.
#================================================
[devices]
wanpipe1 = WAN_AFT_TE1, Comment
[interfaces]
w1g1 = wanpipe1, , TDM_VOICE, Comment
[wanpipe1]
CARD_TYPE = AFT
S514CPU = A
CommPort = PRI
AUTO_PCISLOT = NO
PCISLOT = 4
PCIBUS = 3
FE_MEDIA = T1
FE_LCODE = B8ZS
FE_FRAME = ESF
FE_LINE = 1
TE_CLOCK = MASTER
TE_REF_CLOCK = 0
TE_HIGHIMPEDANCE = NO
LBO = 0DB
FE_TXTRISTATE = NO
MTU = 1500
UDPPORT = 9000
TTL = 255
IGNORE_FRONT_END = NO
TDMV_SPAN = 1
TDMV_DCHAN = 24
TDMV_HW_DTMF = NO
[w1g1]
ACTIVE_CH = ALL
TDMV_ECHO_OFF = NO
TDMV_HWEC = YES
Phone System 