Sip Port...

[womble1]

HI in sip info I can see a remote extension always uses a high numbered port...
Name/username Host Dyn Nat ACL Port Status
502 (Unspecified) D N A 0 UNKNOWN
501/501 •••.•••.•••.••• D N A 49503 OK (102 ms)

never had a problem with the phone, just wondering why it is not using 5060 ? 5060 is stated in the extension setup for that extension...

 

[dswartz]

are you sure the 5060 isn't the destination? i'm guessing the 49503 is the source port?

 

[jroper]

Hi

WHat you see there depends on the what type of NAT device you are using, and is more to do with your router than asterisk. It should be nothing to worry about, and I have never really fully understood why Asterisk shows this with some NAT devices but not others.

Joe

 

[womble1]

Hi

WHat you see there depends on the what type of NAT device you are using, and is more to do with your router than asterisk. It should be nothing to worry about, and I have never really fully understood why Asterisk shows this with some NAT devices but not others.

Joe

I'm using a Zyxel P-661H with pure 1-1 NAT no port forwarding and no firewall...

 

[jroper]

Hi

I enjoy a good turn of phrase, and while having a look at this problem with the aid of Google, I came across this phrase in an article that explains what may be occurring.

Network Address Translation is a steaming kettle of acronym soup

Enjoy

http://www.corecom.com/external/livesecurity/1to1nat.htm

 

[womble1]

Hi

I enjoy a good turn of phrase, and while having a look at this problem with the aid of Google, I came across this phrase in an article that explains what may be occurring.



Enjoy

http://www.corecom.com/external/livesecurity/1to1nat.htm

THanks, but covered all those sases and still not working...

 

[jroper]

Hi

My understanding was your phone was working, you were just curious about the high port number reported.

never had a problem with the phone, just wondering why it is not using 5060 ? 5060 is stated in the extension setup for that extension...

Joe