TIPS How to setup trunk with less info

[shetu]

My local ip phone provider setup a new ip phone number for me and they send only username, password and host name. I can login from from Zoiper5, yate softphone and make call. How do I setup a trunk in Pbx In Flash base on these information?
IPT NUMBER / LOGIN : 096391******
PASSWORD will send to your Mobile Number
Host: sip.icctalk.com

 

[KNERD]

Go to Connectivity -> Trunks -> Add Trunk (pjsip).

Enter those three items, and done.

 

[shetu]

Thanks. I tried on sip trunk. Here is my trunk details.
I can make outgoing call but Incoming call does not enter pbx or just rejected.

 

[dicko]

I have a problem with 'rejected' or just doesn't enter, please post supporting logs of both cases

 

[Samot]

Thanks. I tried on sip trunk. Here is my trunk details.
I can make outgoing call but Incoming call does not enter pbx or just rejected.
View attachment 5241

View attachment 5242

You are using IP only auth since you have no Outbound registration setup (you have Registration set to None). Because of that you need to go into the Advanced tab under PJSIP Settings and add all the IPs the calls could be coming from to the Match (Permit) setting.

When you are doing Outbound Registration, those IPs are automatically added but if you do IP Auth, you need to add them.

 

[KNERD]

Thanks. I tried on sip trunk. Here is my trunk details.
I can make outgoing call but Incoming call does not enter pbx or just rejected.
View attachment 5241

View attachment 5242

You did make an incoming route, right?

 

[shetu]

Hello all,
I changed few things and incoming call send to ivr-demo. Do I put right context there? I tried from-internal and from-trunk.
pjsip settings > Authentication > Outbound
pjsip settings > Registration > Send
pjsip settings > Context > from-pstn

 

[dallas]

pjsip settings > Authentication > Outbound
pjsip settings > Registration > Send
pjsip settings > Context > from-pstn

These are correct. What do you have in pjsip Settings>Advanced>Match (Permit)?

 

[shetu]

These are correct. What do you have in pjsip Settings>Advanced>Match (Permit)?

This field is blank.

 

[dallas]

This field is blank.

You need to enter all the IP addresses that sip.icctalk.com use to send you calls.

 

[shetu]

You need to enter all the IP addresses that sip.icctalk.com use to send you calls.

They do not send any ip address list. How do I find this ip address?

 

[dallas]

You need to talk to them or check their website for that information. I can’t access their website from my country. I can only find a DNS record for 103.15.140.151.

 

[shetu]

You need to talk to them or check their website for that information. I can’t access their website from my country. I can only find a DNS record for 103.15.140.151.

Thanks. I called them, they are not helpful. I try to use wire shark and find ip address.

 

[Samot]

They do not send any ip address list. How do I find this ip address?

You can put the FQDN in the Match (permit) setting. It will look up all IPs for that domain.