Webmin Stopped Working after GoPublic 2020

[jreed1996]

Webmin was working fine on IncrediblePBX 2020 (CentOS7) until I ran the ./Go-Public-2020 script last night. I had already whitelisted my ip address and can see it in iptables. I can ssh to the server just fine. Its just webmin that does not work. I have rebooted the server a few times. Any ideas would be appreciated.

 

[John C. Reid]

SSH in and run systemctl status webmin to ensure the service is running, if not then systemctl run webmin

 

[ostridge]

systemctl run webmin

Query should that be systemctl start webmin ( or one of {start|stop|restart|force-reload|status} ) ??

 

[John C. Reid]

Query should that be systemctl start webmin ( or one of {start|stop|restart|force-reload|status} ) ??

Yes, you got me. I was tired and didn't proofread. Either start or restart should work. I have have a couple servers over the years that for whatever reason Webmin doesn't always restart after a reboot. So the habit has just been to jump into the shell and run the restart option. However, since this is a new issue in this instance, the status is a good idea to see if webmin service not running is the issue before you go arbitrarily running commands.

 

[ostridge]

No worries. I wasn't sure about it on Centos in particular, hence the '?'.

 

[John C. Reid]

No worries. I wasn't sure about it on Centos in particular, hence the '?'.

systemctl is part of systemd, so it should be the same on any Linux distro that is running systemd rather than some other init system (which is most of them anymore.)