QUESTION Figuring out fax setup on PIAF Green / Incredible 11

[danb35]

So about 18 months ago, I installed Incredible PBX 11 in a VM for my home phones (overkill, I know, but why not?). Here's the status screen with versions and such:

At the time, I believe I ran the incrediblefax11.sh script--AvantFax appears to be installed, and I am able to receive faxes to my email.

It's been a long time since I had occasion to send a fax, though, but now I do. And now that I do have occasion to send a fax, I can't remember, and I can't find (if I did write it down), how I set it up. I can browse to the server's IP address, set the slider to Admin, and see the AvantFax button, but it asks for login credentials that I don't have.

There's obviously some configuration set up, and I don't mind blowing it away, but I'm not sure how best to proceed. Any suggestions would be appreciated.

 

[danb35]

Well, with a bit further poking around, I was able to determine that the username to log in to the AvantFax web page was maint, and I was able to further determine the password from there. Now I can log in to the web page, and send a fax from there. Good enough, in the short term.

But... I'd previously had some version of IncrediblePBX running on a Raspberry Pi, and had been able to use a HylaFax client to connect to it and send faxes from my PC without using a web page. Reviewing how that client was configured, it was connecting to port 4559 on the Pi. nmap on my current install doesn't show that port 4559 is open at all, and when I change the IP address in the client to match my current server, the connection attempt times out. Any suggestions on how to proceed with this?