New Purple install - GV outbound broken

[joeg]

Just did an install yesterday of the latest Purple. Love the Google Voice module.

Configured two GV trunks. Both inbound numbers work perfectly. Rings right into PiaF and goes to correct inbound route.

Configured the Default Outbound Route to use my first Google Voice trunk, or GV_9781234567 (obviously not my real number). All outbound calls give an Allison "All circuits are busy - please try your call again later."

Port 5222 is forwarded and correctly configured (inbound calls sure wouldn't work if it wasn't).

Suggestions? Was there some config I missed?

 

[rossiv]

Just did an install yesterday of the latest Purple. Love the Google Voice module.

Configured two GV trunks. Both inbound numbers work perfectly. Rings right into PiaF and goes to correct inbound route.

Configured the Default Outbound Route to use my first Google Voice trunk, or GV_9781234567 (obviously not my real number). All outbound calls give an Allison "All circuits are busy - please try your call again later."

Port 5222 is forwarded and correctly configured (inbound calls sure wouldn't work if it wasn't).

Suggestions? Was there some config I missed?

Could you please post the output of 'status' and the call logs?

 

[joeg]

Let's see - the call log is pretty simple. The DST channel just says

Local/xxxXXXXXXX

and the Disposition is FAILED. I don't have access to the command line at the moment, but when I get it I'll post here.

BTW, everything else on the PBX works perfectly. Have a Vitelity Toll-Free trunk coming in and it works fine. Had high hopes GV would work well, but no go quite yet.

 

[new_bee321]

I am having the exact same problem. when dialing out, after two rings I am also getting "all circuits are busy". I installed the red versing day before yesterday. I have also tried to look into the forum for the solution. did my update fixes etc but still no success. I remember somewhere in the forum, some one suggested that may be the google voice call back is two quick, one should add some delay there. don't know where to add the delay. so need some help here from gurus.

 

[new_bee321]

ok I found the solution. check this thread. it worked for me
http://pbxinaflash.com/community/th...utgoing-says-all-circuits-busy.11112/?t=11112

 

[joeg]

Hi friends,

In all the excitement somehow I never picked up that you have to dial a "1" first. Works fine with that. I'm gonna re-install to get the latest GV module where you don't have to dial a "1". Thanks you for all your help.