Hi all, I'd like any feedback on setting up an additional trunk using the same 4 BRI Patton 4131 to handle a mini multi tenant config with IPBX 2020 (currently using 1 BRI and adding a second BRI with seperate billing/numbering). Please don't scream or rip your hair out - I know Freepbx is not really made for multitenant environments but this is just for 2 specific extensions. I am thinking of routing the incoming calls using the relevant DID to the appropriate ring groups (easy part). Outgoing calls of course with the relevant extensions (only 2) should be routed towards the appropriate trunk using the dialing pattern/CID rules in the outbound routes. On the Patton I can create a second Identity and set it up in freepbx as a second trunk for all this but for outgoing calls the patton does not route based on the incoming "peer" but rather the "CID" (being the same VOIP gateway which is trickier). So I was thinking of setting up a routing rule in the Patton in order to route certain outgoing CIDs (only 2 atm) to the approriate BRI (hope I was clear enough) but have to look into this more in depth. Has anyone any better or more appropriate suggestions? I understand this may be more a Patton related issue at this stage but was wondering if any of you had some experience with this kind of setup already.
Thanks!
Thanks!
Phone System 