Rhino analog card with genzaptelconf not setting up

[tbooth]

followed these instructions outlined from rhino support then ran genzaptelconf and no channels are being setup.

1. All work should be done from /usr/src
cd /usr/src
2. Get the Script
wget http://downloads.rhinoequipment.com/Drivers/Contrib/setup-rhino-se
3. Make the Script Executable
chmod +x setup-rhino-se
4. Run the Script.
./setup-rhino-se
5. You may install the script for future use.
install -m 755 setup-rhino-se /usr/local/sbin/
6. Configure your zapata and zaptel files normally.

Any help or suggestions would be greatly appreciated.
tim

 

[jmullinix]

Tim,

I seem to remember that you have to manually edit /etc/zaptel.conf.

It need to look a little like this:

# Autogenerated by /usr/local/sbin/genzaptelconf -- do not hand edit
# Zaptel Configuration File
#
# This file is parsed by the Zaptel Configurator, ztcfg
#

# It must be in the module loading order


# Span 1: Rhino RCB8FXX/1 "Rhino RCB8FXX/1" (MASTER)
fxsks=1
fxsks=2
fxsks=3
fxsks=4
fxsks=5
fxsks=6
fxoks=7
fxoks=8

# Global data

loadzone        = us
defaultzone     = us
zaptel.conf (END)

You will need to modify to match your card.

 

[tbooth]

well i appear to have the card on irq 7 along with 2 other devices. Let me fix that first.

hmm. tried all slots and still on the same irq with 2 other devices. Supermicro could this be normal?

 

[tbooth]

RESOVLED: FOUND THIS THREAD. THX JOHN.

euser4life

Guru
Join Date: Dec 2007
Location: Shreveport, LA
Posts: 85


There are a few steps missing in the link above that must be done to get everything working. I just installed a test box with a Rhino R4FXO-EC and after running the script you must also do the following:

depmod -a
modprobe rcbfx
Verify that the hardware was detected by running "dmesg |grep rcbfx"

Edit /etc/sysconfig/zaptel and add "rcbfx"

MODULES="$MODULES rcbfx" # R4FXO - Rhino

You can # out any unused modules

now run "genzaptelconf -vvv". Now your channels should configure.