dcookut
New Member
- Joined
- Dec 15, 2007
- Messages
- 5
- Reaction score
- 0
Solved: X100p configures but not running on Re-Boot
PBX in a flash 1.0
I ran genzaptelconf and it worked and card was properly configured
zttool showed the card was ok
the trunk would not show up on reboot in zttool
I found the Zaptel service not running ( think this loads the hardware drivers )
the following command fixed it so that it would load on reboot
root@pbx:~ $ chkconfig zaptel on
PBX in a flash 1.0
I ran genzaptelconf and it worked and card was properly configured
zttool showed the card was ok
the trunk would not show up on reboot in zttool
I found the Zaptel service not running ( think this loads the hardware drivers )
the following command fixed it so that it would load on reboot
root@pbx:~ $ chkconfig zaptel on
Phone System 