SOLVED Upgraded to 2.10 and now the Module admin doesn't work

[ks1905]

Hello All,

I am a total novice when it comes to PIAF and FreePBX.

I manged to get myself in trouble today when I upgraded to 2.10 from 2.9 using the 2.10 Upgrade Tool and now the only module that displays under the Module Admin is (FreePBX Framework 2.10.1.15) which it say is Enabled. I have reinstalled(forced) the 2.10.1.15 Framework a few times with no luck, I have reloaded and also rebooted.

The only thing I can do under the Module Admin is check for more modules but it continues to only display the FreePBX Framework and I cannot get past this point.

The FreePBX System Status says that I have 65 modules to upgrade, but they just don't show up under Module Admin.

Thank you in advance


PBX in a Flash PURPLE


PIAF Installed Version = 2.0.6.2 under *HARDWARE*
FreePBX Version = 2.10.1.15
2.10
Running Asterisk Version = 1.8.8.0
Asterisk Source Version = 1.8.8.0
Dahdi Source Version = 2.6.0+2.6.0
Libpri Source Version = 1.4.12
IP Address = 192.168.1.25 on eth0
Operating System = CentOS release 6.3 (Final)
Kernel Version = 2.6.32-220.2.1.el6.i686 - 32 Bit

 

[leemason]

What happens when you try clicking "Check Online"?

 

[ks1905]

when I "check online" it continues Only to show the framework module as available, no other modules are available. It gives me the option to do a "forced" reinstall, when I do a forced reinstall it does not fix the issue.

I have downgraded to 2.9 and the admin module works but I would like to get up to 2.10 or higher.

 

[Chris Sweeney]

What happens if you run the update script from the command line to update all the modules after you do the framework upgrade? I have a feeling that will fix everything.

 

[jroper]

Hi

I found myself in a similar position, I managed to get out of it by running:-


/var/lib/asterisk/bin/module_admin upgradeall

This put me into a state where I could now use the module admin interface.


Run /var/lib/asterisk/bin/module_admin --help to understand what other useful stuff there is with this command.

Joe

 

[ks1905]

Thank you for the suggestions. I started upgrading from 2.9 today to 2.10 (with the plan of module_admin upgradeall) and there was a new framework available FreePBX Framework 2.10.1.16 (last week was 2.10.1.15) and this fixed my problem.

I am currently running 2.11.0.23. Thank you again for all your suggestions.